About Editing Feature Lines

You can use feature line editing commands with several different object types in addition to feature lines.

Note: You can use the feature line commands to edit survey figures, including control points. You should update the survey database after editing a feature line. If you do not, the next time you recalculate the figure from the database, your edits to the feature lines will be overwritten.

The following table lists which objects are supported for each command.

	Feature Lines	Plot Lines	Survey Figures	3D Polylines	2D Polylines
Level Editor	X	X	X
Quick Level Edit	X	X
Edit Levels	X	X	X	X
Set Gradient/Slope Between Points	X	X	X	X
Set Level By Reference	X	X	X	X
Insert Level Point	X	X	X	X Note: Inserts an IP rather than a level point.
Delete Level Point	X	X	X
Insert High/Low Level Point	X	X	X	X
Raise/Lower	X	X	X	X
Raise/Lower by Reference	X	X	X	X	X
Adjacent Levels by Reference	X	X	X	X
Gradient Extension by Reference	X	X	X	X
Set Levels From Surface	X	X	X	X
Insert IP	X	X	X	X	X
Delete IP	X	X	X	X	X
Join	X	X	X	X
Reverse	X	X	X	X	X Note: This command also supports AutoCAD lines
Edit Curve	X	X	X
Fillet	X		X	X
Fit Curve	X	X	X	X	X
Smooth	X		X
Weed	X			X	X
Stepped Offset	X		X	X	X
Apply Feature Line Names	X
Apply Feature Line Styles	X
Break	X
Remove Dynamic Links	X
Trim	X
Adding a Feature Line to Surface as a Breakline	X
Convert 2D to 3D Polyline					X
Convert 3D to 2D Polyline				X
Edit Polyline Levels					X
Quick Profile	X	X	X	X	X