Configuring Hardware For Clip Input and Output Using a VTR
Important: With Flame Family 2023, VTR capture and VTR output enter maintenance mode: they are no longer qualified or tested by Autodesk.
When preparing for a VTR session, confirm the following:
- Audio and video outputs of the VTR are connected to the audio and video inputs of the Flame system. Audio and video inputs of the VTR are connected to the audio and video outputs of the Flame system.
- The VTR is connected, using an RS-422 video I/O control cable, to enable its remote control from the workstation.
- A video sync signal is connected to the sync input of the video device to ensure frame-accurate capture. If there is a separate audio device, an audio sync signal must be connected to it as well.
Configuring Mac Hardware
Your Mac must be equipped with either an AJA or a Blackmagic Design device to connect to a VTR.
Consult the online System Requirements to see which devices are supported. The actual supported features depend on the device used, but generally includes SDI Capture, SDI Playout, and SDI / HDMI Preview, and 3G I/O when available.