Explanation Lines

ConfigPost allows you to put explanations into any program format. An explanation line has to start with; (semicolon) and it has to end with <eob>.

Example of an explanation line is shown below:

;This is an explanation line, it starts with a semicolon <eob>

During Post Processing PartMaker ignores explanations if the check box "Strip Explanation Lines" is checked in the General Information,Mill or General Information,Turn or General Information,WireEDM dialog see this page.

If "Strip Explanation Lines" is not checked then during Post Processing PartMaker puts all explanations lines into a G-Code file.