Nonlinear Deformer Attributes
Select one of the following options.
- Low Bound
-
Specifies lower extent of the flare on the deformer’s local negative Y axis. Values can be negative numbers or zero. Use the slider to select values from negative 10.000 to 0.000. Default is -1.000.
- High Bound
-
Specifies upper extent of the flare on the deformer’s positive local Y axis. Values can be positive numbers only (minimum value is 0). Use the slider to select values from 0.000 to 10.000. Default is 1.000.
- Start Flare X
-
Specifies the amount of flaring from the deformer’s X axis at the Low Bound. The flaring progresses along the deformer’s local X axis, varying according to the value of Curve. Use the slider to select values from 0.000 to 10.000. Default is 1.000.
- Start Flare Z
-
Specifies the amount of flaring from the deformer’s Z axis at the Low Bound. The flaring progresses along the deformer’s local Z axis to the High Bound, varying according to the value of Curve. Use the slider to select values from 0.000 to 10.000. Default is 1.000.
- End Flare X
-
Specifies the amount of flaring from the deformer’s X axis at the High Bound. The flaring starts at the Low Bound and progresses along the deformer’s local X axis to the High Bound, varying according to the value of Curve. Use the slider to select values from 0.000 to 10.000. Default is 1.000.
- End Flare Z
-
Specifies the amount of flaring from the deformer’s Z axis at the High Bound. The flaring starts at the Low Bound and progresses along the deformer’s local Z axis to the High Bound, varying according to the value of Curve. Use the slider to select values from 0.000 to 10.000. Default is 1.000.
- Curve
-
Specifies the amount of curvature (the profile of the flaring curve) between the Low Bound and the High Bound. A value of 0 specifies no curvature (linear interpolation). Positive values specify outward, bulging curvature and negative values specify inward, hourglass-shaped curvatures. Use the slider to select values from -3.000 to 3.000. Default is 0.000.