Access
Ribbon:
3d Model tab
Freeform panel
Bridge
Note: You can pick points to align the bridge to by selecting a vertex on each loop. The vertices provide the orientation of the bridge. If there is only a single face span, then the two vertices will be connected by a single edge. The arrows show the direction around the loops. The flip buttons flips the direction around the loops.
- Side One
- Enables the selection of the first set of faces.
- Side Two
- Enables the selection of the second set of faces.
- Twists
- Specify the number of complete rotations of the bridge between side one and side two.
- Faces
- Specify the number of faces created between side one and side two.
- Preview
- Displays a full preview of the bridge.