Use the Mirror toolbar to mirror selected curves along one of the principal planes of the active workplane or along an arbitrary mirror line. If no workplane is active, the mirroring is about the relevant plane of the global coordinate system.
To display the Mirror toolbar, click:
- Curve Editor tab > Edit panel > Transformations > Multiple Transform.
- Toolpath Transform tab > Transform panel > Multiple Transform.
- Pattern Transform tab > Transform panel > Multiple Transform.
- Boundary Transform tab > Transform panel > Multiple Transform.
- Workplane Transform tab > Transform panel > Multiple.
- Edit > Transform on the individual toolpath, boundary, pattern, or workplane context menus.
The Mirror toolbar contains the following:
-
Keep original — Select whether the entities are copied or replaced when transformed.
-
Replace original — When displayed, the original entities are replaced with the transformed ones.
-
Keep original — When displayed, keeps both the original and transformed entities.
-
-
Mirror in XY — Click to mirror the entity in the XY plane.
-
Mirror in YZ — Click to mirror the entity in the YZ plane.
-
Mirror in ZX — Click to mirror the entity in the ZX plane.
-
Mirror in line — Click to mirror the entity in a plane defined by selecting either an existing line or two points.
-
Workplane origin — When selected, the active workplane is the origin. If no workplane is active then the global coordinate system is the origin.
-
Bounding box origin — When selected, the origin is the centre of the bounding box containing all the entities.
-
Move origin — When selected, you can move the origin graphically by dragging or by entering coordinates using
,
, or
and
in the
Status bar.
-
Finish — Click to accept the changes and close the toolbar.