Use this dialog to select parameters are displayed in the table.
The name and content of the dialog depends on type of results which is selected from Tables: Data and Results dialog.
The Member Value Selection dialog is composed of the following tabs.
The Nodal Value Selection dialog is composed of the following tabs.
If diagrams for time history analysis are presented and Table Columns is selected from the context menu, the dialog opens. It allows one for selecting parameters that are to be presented in the table located below the diagrams for time history analysis.
The FE Value Selection dialog is composed of the following tabs.
On the Panels tab in the FE result table, Table Columns is available in the context menu. The dialog that opens after selecting the Table Columns includes the General tab.
The Dynamic Value Selection dialog is composed of the following tabs.
The Reduced Results for Panels dialog is composed of the following tabs.
The Results for the required (theoretical) member reinforcement dialog consists of two tabs for RC beams and columns.
The Results for Plate and Shell Reinforcement dialog is composed of the following tabs.
The Results for Solids dialog is composed of the following tabs.
The Data for plastic process history dialog contains the following tabs.
The Forces and Stresses tabs are identical as those for member values.
The following tabs may be also available in the above dialogs:
Resulting loads coming from the Load Take Down analysis can be also reached in the tabular form.
The lower part of the dialog contains two options:
See also: